NX 11 Topics

1. Video 0 – View Commands (7:50)
   • Open a model
   • Zoom in and out
     • (roll mouse wheel)
     • MB2
   • 3D Orbit
     • (move mouse while holding in middle mouse wheel)
     • MB2
   • Pan
     • (move mouse and right click button)
     • MB2 + MB3
   • Twist view
     • M2 + Slide along edges of screen
   • Align view
     • F8
   • Wireframe or Shaded
   • Section view
   • Part Navigator Intro
   • Show and Hide
   • Fit View
     • (Ctrl + F)
2. Introduction to Modeling (23:40)
   • Create a new model
   • Insert design features
   • Insert a sketch
   • Extrude (start, end, offset, draft)
   • Revolve
   • Sketch constraints
   • Don’t let autodimensions push you around
   • Holes
   • Entering a dimension as a formula (fractions)
3. Cylinder – Using Datums (15:29)
   • Curve selection filter
   • Hole without positioning sketch
   • Chamfers
   • Removing objects from a selection
   • Hole on curved surface
   • Datum planes
   • Bisecting datum plane
   • Using Quick Pick
   • Extrude “until next”
   • Layer control
4. Sine Bar (16:42)
   • Constraints from one sketch to another
   • Fillets (edge blends)
   • Datum planes (inferred)
   • Holes positioned to datum planes
5. Assemblies – Bottom up (NX12)